That's the second panel finished
The second panel is up: a bit of a wrestling match, and a lot of work for a very plain bit of fuzzy wall, but it's there. The hidden batten is working nicely though locating it under the insulation and in a roasting van was, er, exciting. And sweaty. Top and bottom batten screws are dressed with the same screw caps as the door panel.
In other news, I've located a Flettner (spinning black plastic) roof vent on Ebay, so that'll be fitted soon. Not a moment too soon, either - it's scorchio!
Next to do: mock up the cable runs, then mark up and offer the driver's side rear panel. This panel will have cutouts for cabling to/from the electrical box, and speaker and lamp mounts. It may also have another document pocket, we'll see.
In other news, I've located a Flettner (spinning black plastic) roof vent on Ebay, so that'll be fitted soon. Not a moment too soon, either - it's scorchio!
Next to do: mock up the cable runs, then mark up and offer the driver's side rear panel. This panel will have cutouts for cabling to/from the electrical box, and speaker and lamp mounts. It may also have another document pocket, we'll see.
0 Comments:
Post a Comment
<< Home